Our new Indie Games subforum is now open for business in G&T. Go and check it out, you might land a code for a free game. If you're developing an indie game and want to post about it, follow these directions. If you don't, he'll break your legs! Hahaha! Seriously though.
Our rules have been updated and given their own forum. Go and look at them! They are nice, and there may be new ones that you didn't know about! Hooray for rules! Hooray for The System! Hooray for Conforming!
Computer problems
Projeck
Registered User regular
Registered User regular
A couple weeks ago, I started getting an error with my desktop on bootup reading "USB overcurrent detected! Computer will shutdown in 15 seconds"
this persists even when there are no USB devices plugged in, and i can't access the BIOS setup either
The motherboard is asus, if that helps any, but I basically have no idea how to go about fixing this
Googled around to no avail, so uh
any ideas?
this persists even when there are no USB devices plugged in, and i can't access the BIOS setup either
The motherboard is asus, if that helps any, but I basically have no idea how to go about fixing this
Googled around to no avail, so uh
any ideas?
Projeck on
Posts
1. Front side USB ports. Even if nothing is connected to them, remove the connectors from the motherboard itself. If the problem stops, there's your issue. If it continues, try step 2.
2. Rear USB ports. Same with #1, but you can't disconnect these. I removed ALL USB devices and continued getting that error everytime I started up. If it's the rear ports, then you may have to check your board for grounding problems.
How I solved mine: I didn't. I went into the BIOS and told it to halt on no errors. That allowed it to boot up. My top 2 USB ports in the back are dead. Well, they provide power, but the system will not detect anything connected to them. The bottom 2 work fine, so that allows me to use a mouse and keyboard. Most sources point to a motherboard grounding issue (Which I've had problems with in the past), so the best thing you can do is re-seat your board. Make sure you don't screw in the risers too tightly or it will cause shorts. I used to have to lift my board up a bit off the case to get it to boot properly, so I'm assuming my laziness has caused the same issue you're having right now.
Edit: Just noticed that you said you can't access BIOS setup. So here's a workaround. Purchase a USB to PS/2 adapter. I have about 20 of the damn things laying around. That will let you connect your keyboard via PS/2 and enter BIOS. If that doesn't work, then try completely re-seating the motherboard. Also, be sure to clear your CMOS battery.
thanks!