A while ago, whilst leaving my exs, the electric gates malfunctioned slammed on the side of my car whilst it was moving forward. Fortunately it caught the "runner" on the side and pulled it off.
I picked up all the bits I could, the runner is still intact, no scratches and the car only had one mild scratch which was easily fixed. It's in the red box on the pic below, with the arrow pointing to it.
(Sorry for the tiny picture, only have mspaint at work and it seems to have wanted to shrink it down to unviewable, Red on Red likely WASN'T the best of ideas either, but it's done now!)
That is no longer attached to the side of the car. Firstly, I'm not technically minded, does anyone know exactly what it's called? And secondly does anyone know where I can get the bits to pop it back on?
Sorry for the vague, non technical thread!
Posts
EDIT: Body Molding! That's what it's called! Or maybe just trim.
(a)
...|...
\__/ (b)
The top flat bit (a) slots in to the body moulding/trims and the bit at the bottom (b) pushes in to a hole in the side of the door panel (it's rounded at the bottom to ease pushing it through the hole, then it's impossible to pull back out). Unfortunately all but one of these has snapped and I have no idea where to get them!
(Ignore the full stops in the ascii, it didn't space properly!)
PSN: SirGrinchX
Oculus Rift: Sir_Grinch
If all else fails, shop around online for em, I'm sure plenty of people have broken those in the past. Good luck
Cheers!
PSN: SirGrinchX
Oculus Rift: Sir_Grinch