The new forums will be named Coin Return (based on the most recent vote)! You can check on the status and timeline of the transition to the new forums here.
The Guiding Principles and New Rules document is now in effect.
Setting up RAID 0 [SOLVED]
Lux782
Registered User regular
Registered User regular
I have been attempt to install a RAID 0 on my computer and I am having issues that seem really strange.
I am attempting to RAID 2 WD Raptors on a Gigabyte GA-EX58-UD5. I setup the bios to allow for RAID and have the two drives hooked up to the motherboard. When I start the computer it recognizes that the HDs are installed and after some scanning asks me to press <Ctrl> + <I> to setup the raid. When I do this I get nothing. It skips over that and continues on with your standard boot procedure. I have tried a different keyboard and I know for a fact the control button works on it (as well as I) . So I am at a loss as to what the issue is.
Any ideas?
Right now it recognizes each drive as a master, should I set one up to be a slave to the other?
I am attempting to RAID 2 WD Raptors on a Gigabyte GA-EX58-UD5. I setup the bios to allow for RAID and have the two drives hooked up to the motherboard. When I start the computer it recognizes that the HDs are installed and after some scanning asks me to press <Ctrl> + <I> to setup the raid. When I do this I get nothing. It skips over that and continues on with your standard boot procedure. I have tried a different keyboard and I know for a fact the control button works on it (as well as I) . So I am at a loss as to what the issue is.
Any ideas?
Right now it recognizes each drive as a master, should I set one up to be a slave to the other?
Lux782 on
0
This discussion has been closed.
Posts